Abstract

TECHNICAL NOTE

Quantitative and differential analysis of ciliate protozoa in rumen content samples filtered before and after fixation

Mariana Fonseca Rossi; Isabel Martinele; Marta D'Agosto

Universidade Federal de Juiz de Fora, Juiz de Fora, MG, Brasil

ABSTRACT

The objective of this study was to assess whether the straining of rumen content samples influences the estimation of protozoal density. Ninety rumen samples were obtained from 30 cattle (three samples per animal). The samples were subjected to one of three treatments at the moment of collection: 1) fixation informalin without straining(control treatment), 2) straining before fixation informalin, or 3)straining after fixation informalin.To test the hypothesis of the variation in the protozoa composition in the samples, multivariate analyses with non-metric multidimensional scaling (NMDS) were carried out. The diversity and density of rumen protozoa were negatively affected by straining before fixation.In the pre-filtered sample, the number of ciliates from the genus Entodinium was reduced, and no individuals from the Diploplastron, Elytroplastron and Eudiplodinium genera were detected; these effects were not observed in the other two treatments. Straining after fixation did not interfere with the diversity of the ruminal community, but the abundance of protozoa was greater thanin the control treatment and significantly greater than in the samples filtered before fixation. These factors suggest that post-fixation straining is the recommended technique to analyze rumen protozoa.

Key words: Ciliophora; Entodinium; ruminal protozoa; ruminant

Introduction

The role that ruminal protozoa play in the nutrition of their hosts is still controversial and varies with the nature of their diet. Therefore, the diversity and density of protozoa and their relationship with other constituents of the microbiota are often examined in studies on ruminant nutrition.

The straining of rumen content samples is widely performed in the analysis of various ruminal parameters. A variety of materials have been utilized for this purpose, including gauze (Ríspoli et al., 2009; Trujillo et al., 2010), nylon (Muetzel et al., 2009), sieves (Eriksson et al., 2004), sackcloth (Martinele et al., 2002), fiberglass(Nhetaetal.,2005)and mousseline (Rezaeian et al., 2004; Naik et al., 2009).

However, the lack of standardization regarding the filter materials used can impair the quantification and identification of ciliate protozoa because some of these materials have pores that are smaller than the body size of some species; this causes these species to be retained in the filter. According to Martinele et al.(2002), straining allows better visualization of smaller species, such as those of the genera Entodinium and Charonina, which can be obscured by plant particles. Nevertheless, the authors noted the need to use filters with pores that are large enough to avoid the retention of any genera of ciliates, as they observed when using filters with pore diameter of 500µm.

In addition to comparing the materials used for straining, this study also considers the timing of the straining because the manipulation of the sample prior to its fixation can be critical to the preservation of ruminal protozoa, as reported by Rossi (2013) after extensive observations of ciliates in vivo. Therefore, it has been hypothesized that the manipulation of rumen content samples by filtering before fixation may influence the quantification of ciliated protozoa and consequently alter the interpretation of the role of these protozoa in the physiology of animal digestion.

Thus, the objective of this study was to evaluate the effects of straining rumen content samples on the composition of the protozoa community before and after fixation informalin using a filter with pores measuring 2000µm.

Material and Methods

Samples were obtained from the middle of the ruminal mass of 30 crossbred cattle. The cattle used in this study had undefined pedigree sand were allowed to graze on farms located in Juiz de Fora, Minas Gerais, Brazil. Before being slaughtered, the animals were deprived of food for 12 hours; during this time they received water ad libitum. Three samples of approximately 20 cm³eachwere collected from each eviscerated rumen. These samples were subjected to three treatments, for a total of 30 samples per treatment. For the first (control) treatment ,the rumen content samples were immediately fixed in 18.5% (v/v) formalin without straining (Dehority, 1984). For the second treatment (pre-straining), the samples were filtered immediately after collection and then fixed in the same 18.5% formalin solution. Finally, for the third treatment (post-straining), the samples were immediately fixed in the formalin solution and then filtered. Straining was performed using two layers of phyllo cloth with pores measuring 2000 µm.

The density of the rumen protozoa per mL was obtained using a Sedgewick-Rafter counting chamber (Dehority, 1984) with the modifications proposed by D'Agosto & Carneiro (1999), and the protozoa present in each sample were identified base don the criteria described by Ogimoto & Imai (1981).

To test the hypothesis that the composition of the protozoa in the samples would vary due to the different filtration treatments, multivariate analyses were carried out with the PAST program (version 2.17b, 2012). The data were organized in a binary matrix (presence and absence) and plotted on a two-dimensional map with non-metric multidimensional scaling (NMDS); the dissimilarity was calculated using the Bray-Curtis index. This is the most appropriate index for multivariate analysis because it is less affected by the number of rare species in the samples, and the stress index calculated by NMDS with two dimensions is a measure of the fitof the data.

A single-factor similarity analysis (a one-way ANOSIM) was applied with 10,000 permutations using the PAST program (version 2.17b, 2012). This analysis reveals if there are significant differences between the means of the similarities ranked among the samples within the same treatment and between different treatments. This analysis results in an R-statistic, which is a measure of dissimilarity between the treatments. R values near 0 indicate high similarity and those near 1 indicate low similarity. For the ANOSIM calculation, the Bray-Curtis index was also used, in which each R value has its corresponding probability.

Finally, the data was submitted to similarity percentage analysis (SIMPER) (PAST program version 2.17b, 2012), which allows us to determine which species are primarily responsible for discriminating between different communities, according to the percentage of dissimilarity between pairs of treatments and presenting the percentage of contribution of each genus to that dissimilarity.

Results and Discussion

The straining process removes gross fibrous material from the sample, thus making the visualization of the ciliate protozoa in filtered samples easier than in unfiltered samples (Figure 1); this is true when the filtration occurs either before or after fixation with formalin.

However, the analysis of similarity (ANOSIM) indicated a significant difference(P<0.05)between the pre-filtered and post-filtered treatments (Table 1), revealinga different composition of species between the two methods. In addition, the pre- and post-filtered treatments presented a dissimilarity measure (R) that was far from zero relative to the control treatment, indicating high pairwise differences between both of these treatments and the control treatment (Table 1). This difference was also supported by the NMDS, in which the control and post-filtered treatments clustered along axis 1, representing 72% of the data analyzed; the pre-filtered treatment was plotted far from the other groups, indicating that the pre-filtered samples are more distinct with respect to the abundance of ciliates found in them (Figure 2).

The abundance and diversity of ciliates were smaller in the pre-filtered treatment (Table 2).This can be observed by the absence of the genera Diploplastron, Elytroplastron and Eudiplodinium in the pre-filtered treatment. However, because these genera were present in the other treatments, their absence may be associated with cell lysis resulting from the manipulation of the sample before fixation and contact with oxygen. Because the ciliate protozoa from the rumen are anaerobic, the exposure of these genera to oxygen can promote the lysis of certain species that are more sensitive to aerobiosis, resulting in the underestimation of their population density.

The genera Isotricha and Dasytricha are normally more represented in the rumen, with percent compositions between 8-11% (D'Agosto & Guedes, 2000; Martinele et al., 2007). In the present study, they had low average abundances (Table 2), with a percent composition of approximately 5%. This may indicate that the isotrichids may have escaped from rumen to the reticle during the fasting period that preceded the slaughter of the animals. The escape of protozoa from the rumen to the reticle during periods of fasting and the subsequent migration of the reticle to the rumen after the animals are fed have been documented in cattle (D'Agosto & Guedes, 2000; Martinele et al., 2007).

Protozoa of the genus Entodinium were the most abundant in all treatments, being the best-represented genus among the populations observed. Additionally, this genus explains much of the dissimilarity of the treatments (20.93%, Table 2), indicating that populations of Entodinium were more abundant in the post-filtered treatment than in the control and pre-filtered treatments (Table2); this indicates that the post-filtered treatment is the most recommended treatment. Because the genus Entodinium can compose up to 90% of the ciliate protozoa in the rumen of cattle (Martinele et al., 2002), the straining of the rumen content after fixation is justified because most species of the genus Entodinium are the smallest species observed in the rumen and are better visualized in filtered samples. However, these species are also more susceptible to the manipulation of rumen samples before fixation (Rossi,2013).Therefore, the straining after fixation favors the visualization of these smaller species without eliminating them.

Conclusions

The straining of rumen samples allows better visualization and identification of the ciliate protozoa. However, when straining is carried out before fixationin formalin, the ciliate diversity and density are reduced, leading to underestimation of these populations. Therefore, it is recommended to filter the rumen content after fixation in formalin.

Acknowledgments

The authors thank Dr. Juliane F. S. Lopes for the assistance with the statistical analyses as well as the Minas Gerais State Research Support Foundation for the Master's Scholarship granted to M. F. Rossi, the CAPES for the Postdoctoral Scholarship granted to I. Martinele and the CNPq for the Productivity Scholarship granted to M. D'Agosto.

Received September 19, 2012 and accepted August 29, 2013.

Corresponding author: marianafrossi@hotmail.com

Publication Dates

History